FITTING INSTRUCTIONS
NOTE: When fitting faucets onto stainless steel sinks, it is difficult to keep the faucet in place while tightening stem nuts, and making sure that the faucet does not crawl on the stainless steel sink after installation.  SPLITKLICK Top Hat nylon splitting washers solves both problems.  The patented gripping teeth on the TOP-HAT washer grip the stainless steel and keep the faucet in place permanently keeping the faucet from crawling and scratching the stainless steel surface.

Place the faucet into the holes on the stainless steel sink.
From the under side of the sink, slide the SPLITKLICK Top Hat nylon splitting washer up the stem of the faucet and tighten the back nut. The patented gripping surface will keep the faucet from moving (crawling) on the stainless steel sink.

REPLACEMENT INSTRUCTIONS
Another problem with regular top hat washers is that they are made from acrylic, which harden, crack, and wear out allowing the faucet to become loose and crawl and scratch the stainless steel surface.  Normal replacement of TOP-HAT washers requires turning off the water and removing the water lines from the facuet.

With SPLITKLICK Top Hat nylon splitting washers, the washer "klicks-apart" permitting you to replace old worn-out washers without disconnecting the pipes, which saves a great amount of time.

Unscrew the back nut and cut the damaged washer away.
Open the SPLITKLICK Top Hat nylon-plitting washer and slip it around the threaded tap stem.
Click the washer together.
After aligning the faucet, tighten the back nut.  The patented gripping surface will keep the faucet from moving (crawling).